Kitchenaid Bottom Freezer Refrigerator Not Cooling 2021

Kitchenaid Bottom Freezer Refrigerator Not Cooling. A new refrigerator may take up to 24 hours to reach optimal temperature after initial installation. Ad find deals on products on amazon.

kitchenaid bottom freezer refrigerator not cooling
Source : www.pinterest.com

Ad find deals on products on amazon. Another issue could be with the condenser fan.

2 Drawer Freezer Refrigerator In 2020 French Door

Another possible problem is a bad evaporator fan motor, which circulates the air from the freezer to the refrigerator. As a result, the refrigerator will not cool.

Kitchenaid Bottom Freezer Refrigerator Not Cooling

Freezer will go to 5 degrees then up to 35 degrees and stay there.From there, the keys on the touch pad become soft keys.Here’s the defrost thermostat for your model, it clips on the top of the evaporator coil:Hit the up or down arrows to go to.

Hold the two buttons on the touch pad down on the left and wait for a 3,2,1 countdown.How to reset the ice maker of kitchenaid refrigerator.I have checked for ice on the cooling fins inside, replaced the defrost timer, replaced the starter relay and cleaned the compressor coils.If everything works, the unit will shut down and 01 will appear on the display.

If it were getting the power it should be getting and stuck you would not be able to hold your hand on the top due to the heat.If the evaporator fan motor is not working, the freezer will not cool.If the freezer vent is blocked, cold air will be trapped in the freezer and the freezer might be too cold.If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective.

If the refrigerator is not cooling properly, check to make sure the refrigerator is turned on.If the refrigerator is still not cool after 24 hours, contact the appliance store or service center where the refrigerator was purchased for assistance.If the start capacitor is defective, replace it.If the start capacitor isn’t working, the compressor may not start.

If vents are blocked, airflow will decrease.Is the cooling function turned on?Left this for a minute and then slide both freezer and refrigerator to coldest temp, however, the damper stayed closed (no air) for 5 minutes.Locate the vents in both the freezer and refrigerator compartments and ensure that there is nothing blocking the air flow.

My kitchenaid refrigerator/freezer ksss48qjx00 will cool for 2 days and then gets too warm.Now it is open, but the air flow is not very high.On most refrigerators, the fan motor will not run when the door is open.On the door jamb, there is a plastic tab.

One of the main reasons for fridge not cooling but freezer works is that the evaporator coils are not working in proper order.Read customer reviews & find best sellersRead customer reviews & find best sellersRemove and replace those parts on the side of the compressor.

Some refrigerators need to be manually turned back on after a power outage or power surge.Sometimes you can even smell the paint.The condenser fan motor draws air over the condenser coils to cool them.The condenser fan motor is located underneath the.

The evaporator coils are filled with frost, so air doesn’t get space to pass through them to get cold.The evaporator fan motor draws air over the evaporator coils and circulates it throughout the freezer.The fan motor could be overheating shortly after it starts operating and thus, not circulating air.The refrigerator could also accidentally be turned off during routine cleaning.

This video from sears partsdirect explains how to troubleshoot problems with your refrigerator when it’s not cooling, including checking for frost buildup and faulty components such as the evaporator fan, the compressor and the temperature sensor.To check the evaporator fan motor, open the freezer door and then manually activate the freezer door switch.To determine if the start capacitor is defective, test it with a multimeter.To reset the ice maker of a kitchenaid refrigerator, do the following:

Turn on the manual switch of the ice maker.Unplug the refrigerator first before ohm testing both parts!